Blaupunkt FRANKFURT RCM 82 Operations Instructions download pdf (Page 31)

80

Traffic Memo (TIM)

This set is equipped with a digital voice

memory, making it possible to automatical-

ly record up to four traffic messages lasting

a maximum of four minutes.

Depending on the length of the new mes-

sage, the oldest messages are automatically

deleted.

If a message is longer than four minutes,

“Overflow” will be displayed after four min-

utes of playback, followed by a beep tone

indicating that the system was unable to

record the message in full.

If a new traffic message is broadcast while

you are listening to the messages, the play-

back will be interrupted and the new mes-

sage will be recorded.

When the set is switched on, any messag-

es that are older than 4 hours will be delet-

ed automatically.

A power antenna might be dam-

aged in a car wash

If you have installed a power antenna, then

please read the warning note at the end of

this section.

Switching TIM on/off

When the set is switched on, you can switch

TIM on or off. To do so,

• press TIM for approx. 1 sec.

• press a preset button which has a traf-

fic information station allocated to it.

or

b) Switch off the priority for traffic an-

nouncements:

• press TA.

“TA” will disappear from the display.

Automatic seek tuning start

(Tape deck and CD changer operation)

If you leave the reception area for the traffic

information station you have tuned into while

you are playing the tape deck or a CD, the

system will automatically start searching for

a new TA station.

If no such station is found within approxi-

mately 30 seconds, a warning beep will

sound every 30 seconds. To switch the

warning beep off, proceed as described

above.

Adjusting the volume for traffic

announcements and the warning

beep

This volume was preset at the factory, but

you can use the DSC function to alter the

setting as desired (refer to the section on

“DSC programming - VAR, TVOL”).

There will be a brief status message in the

top line of the display:

- TIM 2h = TIM is switched on

- TIM off = the function has been switched

off.

If TIM is switched on, any traffic messages

broadcast by the traffic radio station you

have selected will be recorded for 2 hours

after the set has been switched off.

Recording traffic messages

When the audio system is switched on and

you are tuned into a traffic information sta-

tion, any traffic messages broadcast will be

recorded automatically.

When you are tuned into a traffic informa-

tion station, either “TP” or “TA” will appear

under the top line in the display.

TP - The audio system receives traffic mes-

sages broadcast by the station you are

tuned into.

TA - The traffic messages broadcast by the

traffic information station in the broad-

casting network will be recorded.

The station you are tuned into does

not have to be a traffic information sta-

tion (as described for traffic message

reception with RDS-EON).

When the audio system is switched off, it

will still record any traffic messages it re-

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Comments to this Manuals

No comments