Blaupunkt Madrid RCM 105 Operations Instructions download pdf (Page 14)

Madrid RCM 105 (Inland)

30

Changing the audio source

with SRC

Use this button to select between radio, tape,

or CD (option) reproduction.

To switch over,

• Press the SRC button.

Care of your audio equipment

We recommend that you use only C-60/C-90

cassette tapes in your car radio. Protect your

cassettes from dirt, dust and temperatures

exceeding 50 °C. During cold weather, allow

cold cassettes to warm up somewhat before

playing them in order to avoid uneven tape

transport. Operating problems and sound

distortions may occur after approximately

100 hours of playing time and are caused by

dust particles which adhere to the rubber

roller and the audio head.

Use a cleaner cassette to remove normal dirt

build-up. For tougher cases, use a cotton

swab (Q-tip) soaked with alcohol. Never use

any hard tools to clean your unit!

DSC programming

This car radio offers direct software control

(DSC), which allows you to adapt a number

of default settings to your preference and to

store these values.

In the following you will find an overview of all

the default settings adjusted at the factory.

To change a programmed parameter,

• press DSC.

Then use the rocker switch and the -dB

button to select and change the functions

described below. The display shows the ad-

justed status.

Select function

Select function

Change-

setting

Change-

setting

CDC NAME (only, if changer is connec-

ted)

Use this function to name

your discs (see also CD

changer control, “Entering/

displaying CD names”)

ANGLE Select one of the values -1,

0, or +1 to adapt the indivi-

dual viewing angle.

Adjust the ANGLE so as to

provide the best view.

BEEP Acknowledgement tone for

all functions where the re-

spective button has to be

held down for more than 2

seconds to activate the

function.

Adjust volume between 0

and 9 (0 = OFF).

BRIGHT The display brightness can

be adjusted between 1 and

16. You may set one day

and one night adjust-

ment.Brightness of night

illumination:

Switch on the vehicle’s light-

ing system and program the

brightness value. For this,

the lighting connector has to

be connected to the electric

system of the car.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments