TravelPilot RGS 05Fitting instructions8 622 400 046 7 612 001 120
- 27 -Fig. 9 Fig.10 loop loopFig. 8Fig. 7Fig. 6
- 28 -Connecting the sensors for the navigation unit, Fig. 11Kl. 1512VKl.30+12V+5APrecision resistor Wheel sensor Loudspe
- 29 -Mounting the DisplayFig. 12Fig. 13Fig. 15Fig. 16Fig. 18Fig. 14Fig. 17
- 30 -Service ChecklistCheck the following points during servicing!1) Is the operating power supply all right?2) Is the basic navigation unit mounted
- 31 -Load the installation diskSelect „wheel sensor test“ and drive straight on.Are the impulses for wheel 1 and 2 the same?Is the difference between
- 32 -Error: Locating loss when the rear window defogger is switched onand the magnetic field sensor has been mounted on the rear windownonoReplace th
- 33 -Error: Regular locating loss even after a short drivenoyesnonoyesLoad the installation disk.Select „find compass location“, then select„compass
- 34 -nonoError: Regular locating loss due to constant magnetic changes in the vehicleJack up the vehicle.Load the installation disk.Select „find comp
- 35 -Error: Occasional locating loss due to electrical equipment in the vehiclenoError: „CD reading error“ appears in the displaynoyesnoyesLoad the i
- 36 -noyesError: No GPS satellite reception for several daysCheck the connection wire from theGPS receiver to the navigation andthe power supply.yesn
- 19 -GBSafety instructionsInstallation and connection regulationsWhile installing and mounting this equipment, you mustdisconnect the negative termin
- 20 -Wheel sensors and magnetic strips Fig. 4Safety instructionsNever screw the wheel sensor clamp onto any stress-bearingparts.Never drill holes in
- 21 -Componentry Fig. 1Operating PanelNavigation unit
- 22 -Componentry Fig. 1GPS receiver GPS antennaPrecision resistor Magnetic field sensor
- 23 -Componentry Fig. 1LoudspeakerDisplayWheel sensors (2x) Wheel sensor extension cord (2x)
- 24 -Mounting materialUBattterminal 30redgroundbrownIgnitionterminal 15blackPositive-negative connection Fig. 2
- 25 -+HeckscheibeChassisHeckscheibeConnection block for the navigation unitprecision resistormeasuring wire 50 cmPrecision resistor connection Fig. 3
- 26 -Installation tolerances for the wheel sensors Fig. 5Clearance Z: Z = 6.5 mm ± 1.5 mmOffset Y: The centre of the sensor must be located over thee
Comments to this Manuals