Blaupunkt FRANKFURT RCM 104 User Manual download pdf (Page 15)

37

Frankfurt RCM 104

DEUTSCH

ENGLISH

ITALIANO

PORTUGUES

NEDERLAND

ESPAGÑOL

SVENSKA

FRANÇAIS

Traffic Memo (TIM)

This set is equipped with a digital speech

memory, allowing up to 4 traffic messages

lasting a maximum of 4 minutes to be auto-

matically recorded.

As soon as “TP” is displayed, the system will

record all incoming traffic announcements of

the adjusted station.

If the priority for traffic announcements is

activated (“TA” lights up in the display), the

set will also record the traffic messages of the

traffic station program within the same radio

network (see also “Reception of traffic an-

nouncements with RDS-EON”).

Depending on the length of the new traffic

bulletin, the oldest messages will be deleted.

If a message is longer than four minutes, the

system will display OVERFLOW after four

minutes of playback, and release a beep tone

to indicate that the message could only be

recorded partially.

Warning

The motor antenna could be damaged in

a car wash.

If you have installed a motor antenna, then

please take into account the corresponding

warning note at the end of this chapter.

When pressing TIM once again, you will hear

the message text recorded until that interrup-

tion.

Setting the time in the DSC menu:

TIM needs the exact time in order to operate

precisely. The time also has to be re-adjusted

after every interruption of the power supply.

• Press DSC and the time will be display-

ed.

• Press << to set the hours or >> to ad-

just the minutes.

The corresponding value is flashing.

To change the setting,

• press the rocker button

/ .

To confirm your entry,

• press -dB or DSC.

When pressing the -dB button, you can go on

working in the DSC menu immediately.

Adjusting the TIM standby mode/TIM

time

The TIM-TIME to be set corresponds to the

planned departure time. TIM will then be

active 1.5 hours before and after this adju-

sted time, so that the traffic messages will be

recorded during a period of three hours.

Note: During this period, a motor antenna will

remain extracted. Please take into account

the warning note of the end of this chapter.

Recalling stored traffic announcements

• Press the TIM button briefly.

The display for example shows: NDR2 (sta-

tion name or frequency), then briefly

T4 14.30 (T4 = traffic message 4, recorded

at 14:30). If four traffic messages were recor-

ded, then “T4” always represents the most

recent announcement, which will also be

played first.

Use the

/ rocker button to switch between

T1 and T4.

Hold down the / rocker button to move

through the message in forwards/backwards

direction quickly.

Press << to go back to the beginning of the

currently played message.

The TIM function is switched off by either

pressing TIM or >>.

TIM standby mode when the radio is

turned off

With this system it is possible to record inco-

ming traffic announcements automatically at

pre-determined times when the radio is tur-

ned off.

You may then recall such messages as des-

cribed above.

If you press the TIM button while a traffic

announcement is being played (TA lit up in

the display), the recording will be interrupted.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments