Blaupunkt FRANKFURT RCM 104 User Manual download pdf (Page 6)

Frankfurt RCM 104

28

the corresponding slot above the

flashing KeyCard tongue.

Read also the information given in the

“KeyCard” chapter.

9 AF button (alternative frequency) du-

ring RDS operation

When “AF” lights up in the display, the

system will automatically seek a fre-

quency offering better reception of the

same RDS program.

“AF” on/off: Press the AF button briefly.

When pressing the AF button for about

2 seconds, the display will show REG-

ON or REG-OFF (see also chapter

REG - Regional).

: PTY button

Use this button to enter the PTY mode.

In this mode, the preset buttons are

used to select different program types,

e.g. SPORT. The system will then only

seek stations offering sport programs.

; TIM/TA

TIM (TraffIc Memo)

To play all the stored traffic announce-

ments:

Press TIM briefly.

To activate/deactivate the priority for

traffic announcements:

Press TIM for approximately 2 seconds.

TA (Traffic Announcement)

If TA lights up in the display, the system

will only play traffic stations.

TA on/off: Press the TIM button for

approximately 2 seconds

< 1, 2, 3, 4, 5, 6 - preset buttons

You can store 6 stations on each FM

memory bank (I, II, and “T“) and

another 6 stations on MW and LW

each.

To store a station: Press button during

radio operation and hold down until the

radio comes on again.

To recall a station: Select the wave-

band. On FM, select the desired memo-

ry bank and press the corresponding

preset button.

= PS

For briefly playing all receivable stati-

ons or the titles during tape or changer

operation (option).

To start/stop Scan: Press PS briefly.

The scan time can also be altered (see

chapter “DSC programming” - SCANTI-

ME).

> RM (Radio Monitor)

Press this button to listen to the radio

while fast forwarding or fast rewinding

the tape.

During tape operation:

To switch RM on/off: Press RM.

When this function is activated, the

display shows “RM”.

The radio is played during fast tape run.

? B•C – Dolby NR

This set allows you to play back tapes

that have been recorded with Dolby-NR

B, Dolby-NR C or without Dolby noise

reduction.

Press B•C to adjust to the type of Dolby

NR in which the tape was recorded or

to disengage Dolby NR. When Dolby is

active, the corresponding indicator “B”

or “C” will light up.

@ Eject button

Press

.

A Cassette loading slot

Insert tape (side A or 1 facing up, the

open side showing to the right).

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments