Blaupunkt BRISTOL CD36 User Manual download pdf (Page 7)

30

Switching on/off

You can switch the device on/off in the

following ways:

Switching on/off using the vehicle

ignition

If the device is correctly connected to

the vehicle’s ignition and it was not

switched off using button 1, it will

switch on/off simultaneously with the

ignition.

Switching on/off using button 1

➮ To switch on the device, press

button 1.

➮ To switch off the device, press and

hold down button 1 for longer

than two seconds.

The device switches off.

Note:

● To protect the vehicle battery, the

device will switch off automatically

after one hour if the ignition is off.

Switching on by inserting a CD

If the device is switched off and there

is no CD present in the drive,

➮ gently push the CD with its printed

side uppermost into the drive 5

until you feel some resistance.

The drive draws in the CD automati-

cally.

You must not hinder or assist the drive

as it draws in the CD.

The device switches on and starts play-

ing the CD.

➮ First, pull the control panel straight

off the unit and then out towards

the left.

The device switches off.

All the current settings are saved.

Any CD already inserted in the unit re-

mains there.

Attaching the control panel

➮ Slide the control panel from left to

right into the unit’s guide.

➮ Carefully press on the left edge of

the control panel until it clicks into

place.

Note:

● When attaching the control panel,

make sure you do not press the

display.

If the device was still switched on when

you removed the control panel, it will

automatically switch on again with the

last settings activated (i.e. radio, CD,

CD changer or AUX) when the panel

is replaced.

SWITCHING ON/OFFCONTROL PANEL

02Bristol_VancCD36 gb 07.02.2006, 15:42 Uhr30

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments