Nav Plus Installation – Phase 1
(Location of GPS antenna/receiver)
1g.
Using 2” Velcro strips, I attached my GPS antenna up inside the dash area (above the inst. Cluster). You can’t see it
from this location, but when you have the cluster out, you will notice a little “cubby hole” area where you can insert
the GPS. I put the Velcro strips down first, then wrapped my GPS in Velcro; it’s in there pretty tight. As for
reception, I average 5 or 6 GPS satellites received most of the time (a minimum of 3 is needed).
As for the remaining wire, you can also wrap it in Velcro and stuff in that same cubby area. I decided to run the GPS
wire (see “G”) in between these metal support pieces (not required for everyone else).
G
G
GPS wire: leave yourself 3 feet of slack
from here to behind your HU area.
GPS is located up here
using Velcro strips.
Updated: 7/19/2004
Comments to this Manuals