Blaupunkt SYDNEY RCM 128 User Manual download pdf (Page 8)

34

When this function has been activated,

“RM” shows on the display panel.

The radio is played back during fast

tape run.

B

Press to eject the tape.

C 1, 2, 3, 4, 5, 6 - preset buttons

On FM, you can store six stations for

each of the memory banks I, II and T.

On MW/LW, you can store six stations

each.

To store a station: Press a preset

button during radio operation and hold

down until the set resumes play after

the muting and you hear a beep.

To recall a station: Select the desired

waveband. On FM, also adjust the

corresponding memory bank. Then

press the relevant preset button briefly.

Extra function preset buttons

To store and recall a PTY programme

type.

On FM, you can store and recall one

programme type on/from each preset

button when PTY is active (“PTY”

lights up in the display).

D Cassette loading slot

Insert the tape with side A or 1 facing

up, the open side showing to the right.

E

Tape side selector

Press this button to switch over to the

other side during tape operation. The

display shows “TR 1” or “TR 2”.

F B

Dolby B NR*

Press this button to play back a tape

which has been recorded with Dolby-B

noise reduction. When this button is

pressed, „B“ lights up in the display.

* Noise Reduction system manufactured under li-

cense from Dolby Laboratories Licensing Cor-

poration. „Dolby“ and the double-D symbol are

trademarks of Dolby Laboratories Licensing Cor-

poration.

G LD

Loudness - When listening at a low

level, the Loudness function creates a

more natural sound by boosting the

low frequency range.

LD on/off: Press the button.

When the Loudness function is active,

“LD” will light up in the display.

See chapter “DSC programming” for

more information.

? SRC (source)

You can switch between the different

audio sources radio, tape, and CDC/

AUX (if activated).

@ DIS

Radio operation

When pressing the DIS button, the fre-

quency will be displayed for approxi-

mately four seconds.

Tape operation

When pressing the DIS button, the sta-

tion name/frequency will be displayed

for approximately four seconds.

Changer operation (optional)

To switch the display mode and select

between name, time (playback time)

and number (disc number):

• Press DIS briefly.

A RM (Radio Monitor)

Press this button to listen to the radio

while fast forwarding or rewinding the

tape.

To switch RM on/off: Press RM.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments