Blaupunkt MP3000 User Manual download pdf (Page 17)

ENGLISH

E-16

Installations

Supplied Mounting Hardware

Sleeve

Bushing, Locking Mounting Strap Release

Screw screw and Screw Keys

Precautions

• Be sure to detach the front panel before you start in-

stalling the unit.

• Choose the mounting location carefully so that the unit will

not interfere with the normal driving operations of the driver.

• Use only the supplied mounting hardware for a safe and

secure installation.

• When mounting the unit in a car, keep the unit as level as

possible. If the unit must be mounted at an angle, due to the

design of the vehicle, make sure that the unit does not tilt

upward by more than 30°.

• Turn-off Demo mode before use.

Mounting Example

Installation in the dashboard.

1. Install the sleeve in the dashboard.

2. Select and bend the appropriate tabs to hold the sleeve

firmly in place.

Mounting Strap Use

3. Attaching the Mounting Strap to the underside of the

dash board, using screw.

Attach the back of the unit to the Mounting Strap us-

ing the support stem bolt and hardware.

Bushing Use

3. As shown in the figure below, securely fasten the

screw, which has been inserted into the bushing to

the rear of the set.

Fire wall

The distance to the fire wall var-

ies due to the type of the car. Be

sure to secure the unit by prop-

erly inserting the bushing.

Caution

Insufficient fastening of the

screw may cause some CD’s to

skip.

If your car has no accessory position on the

ignition key switch (POWER SELECT switch)

The illumination on the front panel is factory-set to be turned

on even when the unit is not being played. However, this set-

ting may cause some car battery wear if your car has no ac-

cessory position on the ignition key switch. To avoid this battery

wear, set the POWER SELECT switch located on the bottom

of the unit to the B position, then press the RESET button.

The illumination is reset to stay off while the unit is not being

played.

Reset button

Press the reset button with the point of

a sharp object such as a ball-point pen.

POWER SELECT SWITCH

(Located on the bottom of the unit)

Change the position with a jeweler’s screwdriver, etc.

A : Your car has an accessory position on the ignition

switch.

B : Your car has no accessory position on the ignition

switch.

Be sure to

press the reset button after changing the

switch and connecting the lines.

Note

If set to the

position, demonstration mode will be elimi-

nated.

MP3000_body_en 9/4/01, 4:24 PM16

1 2 ... 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Blaupunkt MP3000 User Manual Page 17

Comments to this Manuals

Related products and manuals for Car media receivers Blaupunkt MP3000